How to Maintain Pneumo-Hydraulic Boosters？
如何维护气体液压增压器?
How to Maintain Pneumo-Hydraulic Boosters？
压力机有很多维护预防措施。可以根据以前的中性和使用后将其分为三个主要块。为所有人编制的气体液压增压器的相关维护知识，仅供参考。在日常的生活中，稳压器的使用还是比较广泛的，那么如何维护气体液压增压器?
Presses have a full set of maintenance precautions, which are classified into three parts: pre-operation, in-operation and post-operation. Below is a compiled maintenance guide for pneumo-hydraulic boosters for your reference. Such boosters are widely used in practical applications. Here are the maintenance instructions for pneumo-hydraulic boosters？
如何维护气体液压增压器?
How to Maintain Pneumo-Hydraulic Boosters？
1.检查石油池，石油水平和石油标签是否符合规定的标准。
2.检查按钮是否灵活以及是否存在阻力。
3.检查电动机接地线是松动，掉落还是损坏。如果有松动，则应将其收紧，并应通知维护人员进行治疗。
4.检查安全保护设备是否完整且可靠。
5.检查每个手柄是否灵活。
6.拧紧并松开坚果。
7.启动液压泵以检查液压泵是否良好，并堵塞密封位和管道。
8.检查限制开关的功能是否良好，以及块的定位是否正常。
9.注意温度升高和音频始终是否正常。
Check the oil sump to ensure the oil level and oil grade comply with specified standards.
Verify that all buttons operate flexibly without jamming.
Inspect the motor grounding wire for looseness, detachment or damage. Retighten loose connections immediately and report faults to maintenance personnel for handling.
Check whether all safety protection devices are intact and functional.
Ensure each handle moves flexibly.
Fasten all loose nuts.
Start the hydraulic pump and check its operating condition; inspect sealing points and pipelines for leakage.
Test the limit switches for normal operation and confirm accurate positioning of travel stops.
Keep monitoring temperature rise and operating sound to ensure they remain within normal range.
气体液压增压器使用后维护是怎么样的?
Post-operation Maintenance of Pneumo-Hydraulic Booster？
1.检查并清洁每个活动网站。
2.将每个控件手柄的开关放置在零位置。
3.检查，清理，组织工作面和工作区域。
Inspect and clean all moving parts.
Set the switches of each control handle to the zero position.
Inspect, clean and organize the working surface and working area.
气体液压增压器的六个预防措施是什么?
Six precautions for pneumo-hydraulic boosters？
1.所有返回管道和机油泄漏管的出口要在油面下面深处，以避免泡沫和进入空气。
2.当液压系统的工作压力或流动可能造成危险或事故时，应该有一个保护装置。
3.如果需要液压传输部分，则不应有工作行程限制开关。
4.当液压系统中有自动或人工控制设备相互连接时，如果任何故障会造成人身安全和设备损坏，则要安装锁定设备。
5.当液压系统处于停车位，并且从阀，管道和执行组件中泄漏的油会造成设备的损坏或危险，要采取措施来防止液压油泄漏燃油箱。
6.液压系统(由液体增压泵和盒子组成)应该有一个人工控制设备，应通过紧急制动或紧急返回控制控制，应满足以下要求：
The outlets of all return pipelines and oil drain pipelines shall be placed deep below the oil level to prevent foaming and air intake.
Protective devices shall be provided if the operating pressure or flow of the hydraulic system may lead to dangers or accidents.
No working stroke limit switches shall be installed on the hydraulic transmission section where it is put into use.
When automatic and manual control devices in the hydraulic system are interconnected, locking devices shall be installed if any fault may cause personal injury and equipment damage.
When the hydraulic system is at standstill, take measures to prevent hydraulic oil from leaking out of the oil tank, since oil leakage from valves, pipelines and actuating components may cause equipment damage or hazards.
The hydraulic system composed of liquid booster pump and tank shall be fitted with manual control devices. It shall be controlled by emergency brake or emergency return and shall meet the following requirements:
以上就是小编为你整理的如何维护气体液压增压器的相关知识，现在气体液压增压器使用还是比较广泛的，现在我们也是能很好的认识这个机器的，目前在工厂中还是比较多的，当然平时的维护一样的非常重要，千万不可忽视。
Here is all the knowledge about the maintenance of pneumo-hydraulic boosters compiled for you. Nowadays, such boosters are widely used. We have gained a thorough understanding of this equipment, which can be commonly seen in factories. Routine maintenance is extremely important and must not be overlooked.